Special Safety Information; Overview Of The Components; Intended Use - AEG SR 4347 Instrucciones De Servicio

English
36

Special safety information

This device works with a class 1 laser.

Overview of the Components

1 Handle
2 FM Dipole antenna
3 CD compartment
4 Loudspeaker
5 Tab for opening the CD tray
6 TUNING control / Radio scale
7 button (Play/Pause)
8 button (Stop)
9 MODE button (Repeat/random playback/Memory)
10 / bttons (next/previous song)
11 LCD display
12 SNOOZE buttons
13 VOL+/AL 1 / VOL-/AL 2 bottons (volume/alarm time)
14 SLEEP/TIME SET button
15 BAND/ALBUM button
16 ST/FUNC button (standby/operation / operating mode)
17 AUX-IN socket
Reverse
18 AC Mains connection
Underside (not shown)
Battery compartment

Intended Use

This device is used for
• The reception of radio programmers
• Playing back audio/MP3 CDs.
• Sound playback from external audio sources.
It is intended exclusively for this purpose and may only be
used as such.
It may only be used in the manner described in these instruc-
tions for use. The device must not be used for commercial
purposes.
Any other use of this device is considered to be contrary to
the intended use and may result in damage to materials or
even personal injury.
The firm ETV – Elektro-Technische Vertriebsgesellschaft mbH
does not accept any liability for damage caused as a result of
the use of this device contrary to its intended use.
Start-up of the device/introduction
• Please read the operating instructions carefully before
using the device for the first time!
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power Supply
• Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed 230 V / 50 Hz
safety power socket and the mains connector AC on the
back of the machine.
• Ensure that the voltage is the same as that indicated on
the model identification plate.
Inserting the Batteries (not supplied)
• Open the lid of the battery compartment on the bottom.
• Insert 6 batteries of type UM2/R14 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
• If the device is not used for a long period of time, remove
the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
Setting the clock (during standby mode)
1. Briefly hold down the SLEEP/TIME SET button (14). The
display will show "24 H".
2. Use the / button (10) to select between 24-hour and
12-hour display setting. Confirm with SLEEP/TIME SET.
NOTE: The 12-hour setting will result in the following
display
AM = morning, PM = afternoon
3. Use / buttons to set the hours. Confirm with SLEEP/
TIME SET.