Maintenance; Trouble Shooting - Dexter 500HD2.5 Manual De Instrucciones

FR

7. MAINTENANCE

ES
PT
Disconnect from the power supply immediately if the supply cord is damaged.
IT
Take care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a qualified repair person (always
replace the two brushes at the same time)
EL
PL
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of commercial solvents and
UA
may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
RO
Lubrication
All the bearings in this tool are lubricated with a su
EN
conditions, therefore no further lubrication is required.

8. TROUBLE SHOOTING

Suspected malfunctions are often due to causes that the users can fix themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
authorised service centre or a similarly qualified specialist if you cannot solve the
problem yourself!
Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord of this power tool is damaged, it must be replaced by a
specially prepared supply cord available through the service organization;
WARNING! Only perform the steps described within these instructions! All
further inspection, maintenance and repair work must be performed by an
nt amount of high grade lubricant for the life of the unit under normal operating
194 257