Arming To Stay Mode - 2gig Technologies Go!Control Guia Del Usuario

Arming to Stay Mode

Use Stay Mode to arm the system when anyone will be staying home. Stay Mode normally has an
Entry Delay so someone with a User Code can re-enter without causing an alarm.
1. Close all protected perimeter doors and windows before arming.
2. Verify that the button on the Control Panel is lit green indicating that the system is ready
to arm. The SECURITY button and ARM button on the display will also be green when all
sensors are closed.
✓ NOTE: If you desire to arm the system quietly without sounding any announcements,
press the button before performing the next steps, select the SILENT EXIT check
box on the Arming Screen, or press SILENCE during the Exit Delay.
3. From the Security Screen, or the Menu Screen, press ARM.
• If there are any open perimeter door or window sensors, the Bypass Screen will appear.
Close all the sensors displayed or press BYPASS ALL to force bypass the displayed
sensors. NOTE: BYPASSED SENSORS WILL NOT BE ABLE TO TRIGGER AN ALARM.
• To bypass sensors, you will need to enter a User Code unless
the installer has set the system for " Quick Bypass".
4. On the Arming Screen, the ENTRY DELAY check box option can be used with Stay Mode.
• If no one is expected to re-enter, the system can be armed without an Entry
Delay. All perimeter doors will trigger the alarm instantly. To arm with all exit/
entry perimeter doors as instant, un-check the ENTRY DELAY option button.
5. Press STAY to arm the system.
• To arm the system, you may need to enter a User Code if your
installer has turned off the system's " Quick Arming" feature.
6. The system will arm and show the Exit Delay counting down. When the Exit Delay expires, the
system is fully armed in the Stay Mode.
The Security Screen
Entry Delay
Checkbox
Entry Delay Check Box
Burglary Protection
The Arming Screen
Quick Exit Button
Quick Exit
Button
11