Brightness / Volume; Backlight Timeout - 2gig Technologies Go!Control Guia Del Usuario

Brightness / Volume

The brightness of the Control Panel's display and the volume of the system's speaker can be adjusted
to best suit the installation.
To set the brightness and volume, use the
following steps:
1. On the Home Screen, press SECURITY.
2. On the Security Screen, press MENU.
3. On the Menu Screen, press TOOLBOX.
4. Enter the a valid User Code
to access the toolbox.
5. On the Toolbox Screen (1 of 3),
press BRIGHTNESS / VOLUME.
6. The top bar on the display sets the
display brightness. The level can
be adjusted from 1 to 12 using the
buttons on each end of the bar.
7. The bottom bar on the display
sets the speaker volume for the
chimes and announcements. This
setting does not affect the alarm
sounder volume. The level can
be adjusted from 1 to 12 using the
buttons on each end of the bar.
8. When fi nished press OK.

Backlight Timeout

The backlight timeout sets the length of time that the display stays lit after use. It can be adjusted to
30 seconds, 1, 2, 5, or 10 minutes, or to "always" to light the display at all times.
✓ NOTE: To conserve the Control Panel's backup battery, during an AC power failure, the
display will go dark after 30 seconds regardless of this setting.
To set the display backlight time, use the
following steps:
1. On the Home Screen, press SECURITY.
2. On the Security Screen, press MENU.
3. On the Menu Screen, press TOOLBOX.
4. Enter the a valid User Code
to access the toolbox.
5. On Toolbox Screen (1 of 3),
press the → arrow.
6. On the Toolbox Screen (2 of 3),
press BACKLIGHT TIMEOUT.
7. Choose one of the display
backlight times and press OK.
System Toolbox
Toolbox Screen One
Brightness / Volume Screen
Toolbox Screen Two
Backlight Timeout Screen
39