Tramontina AP1000T Manual De Uso Y Mantenimiento página 14

Bordeadora de césped eléctrica
Ocultar thumbs Ver también para AP1000T:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
To turn off the trimmer, just release the switch.
Table 1 presents the recommended size of the extension cord to be used based on its length and the
voltage of the electrical network.
The caliber of the electric cable must be in accordance with the table 01:
10 m
Section in
127 V
2 x 1 mm
220 V
2 x 1 mm
Form of usage
Keep the switch pressed down and lift the trimmer about 3 cm from the ground. In this position move
slowly the trimmer from one side to another to promote the trimming of the grass.
Never use the trimmer without the protector or when it is damaged, since the protector helps in the
refrigeration of the motor, limits the length of the nylon string and is a safety device for the operator.
It is recommended to give an interval for rest of 2 minutes after 15 minutes of continuous use, thus
ensuring greater useful life to the motor and thus preventing an overload.
This equipment is recommended for occasional (use domestic) use in lawns of up to 100
square meters, to do the outlines, edges and corners. The area may be larger or smaller
depending on conditions of use: type of grass, height of grass, the temperature, humidity,
etc.
Do not overload the trimmer by entering into tall grass. If needed, carry out several cuts
starting on top and going down to smaller cuts. Do not use on humid or wet grass.
For any maintenance and control operation, the electric cable must be disconnected from
the outlet.
Spool refill
Keep the spool housing (1) fixed and turn the top cover of the spool (2) in the counterclockwise direction
[Fig. 06, page 05].
Remove the used spool (3) and place the new spool, causing the string to pass through top cover
output opening of the spool [Fig. 07, page 05].
Then replace the assembly top cover and spool (4) pressing it against the spool housing (1), and turning
it in the clockwise direction until the latch snaps [Fig. 08, page 05].
20 m
30 m
2 x 1 mm
2 x 1,5 mm
2
2
2 x 1 mm
2 x 1 mm
2
2
MAINTENANCE
40 m
50 m
2 x 2,5 mm
2 x 2,5 mm
2
2
2 x 1 mm
2 x 1 mm
2
2
2
13
60 m
80 m
2 x 2,5 mm
2 x 4 mm
2
2
2
2 x 1 mm
2 x 1,5 mm
2
100 m
2 x 6 mm
2
2 x 1,5 mm
2
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ap1500t

Tabla de contenido