LiftMaster 1220EM FS2 Manual Del Usuario página 26

ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Center the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Metal Doors: Drill 3/16" pilot holes and fasten the
bracket with the 1/4"-14x5/8" self-threading screws
provided.
• Wood Doors: Drill 5/16" holes and use 5/16"x2"
carriage bolts, lock washers and nuts (not
provided) or 5/16"x1-1/2" lag screws (not provided)
depending on your installation needs.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Header Wall
Finished Ceiling
2x4 Support
Header
Bracket
Door
Bracket
Optional
HORIZONTAL AND VERTICAL
Placement
REINFORCEMENT IS NEEDED FOR
of Door
LIGHTWEIGHT GARAGE DOORS
Bracket
(FIBERGLASS, ALUMINUM, STEEL,
DOORS WITH GLASS PANEL, ETC.).
(NOT PROVIDED)
Vertical
Centerline of
Garage Door
For a door with no exposed framing,
or for the optional installation, use
lag screws 5/16"x1-1/2" (Not Provided)
to fasten door bracket.
HARDWARE SHOWN
Self-Threading Screw
1/4"-14x5/8"
Door
Bracket
Nut
5/16"-18
Door
Bracket
26
ACTUAL SIZE
Self-Threading
Screw
1/4"-14x5/8"
Top of Door
(Inside
Garage)
Top Edge
of Door
Optional
Placement
METAL DOOR
Lock
Washer
5/16"
Top of Door
(Inside
Garage)
Top Edge
of Door
Optional
Placement
Carriage Bolt
5/16"x2"
(Not Provided)
WOOD DOOR