SPIT DWS 225 Manual De Instrucciones página 8

Carton contents
1.
2.
3.
4.
5.
6.
7.
DO NOT OPERATE THIS TOOL UNTIL YOU READ AND UNDERSTAND THE
ENTIRE INSTRUCTION MANUAL!
Installation of a sandpaper disc
Unplug the machine (1).
Peel away the worn sanding paper disc, leaving the sponge-backing pad in place.
Carefully center the new sandpaper disc and press into place. It will be held securely by
the hook and loop backing (2).
Replace the hook and loop sponge pad
Unplug the machine (1).
1
Hold the sanding plate in one hand and with the other, using the L-hex wrench
(supplied) fist break free the center bold clockwise (1/8 turn only).
Then only use the L-hex wrench to hold the center bolt from turning and spin off the
sanding plate counterclockwise (3).
The sponge pad must be perfectly flat to get good sanding results. If it is deformed or
damaged it will cause very uneven sanding. Always replace it when damaged. It is hook
and loop pad on both sides, so to replace it, peel it away from to hook and loop pad on
the sanding plate base and, taking great care to keep it perfectly centered, affix a new
2
one.
`
The brush bristles on the edge of the sanding plate cover
The brush bristles on the edge of the sanding plate cover serve two purposes. They
keep the sanding disc properly aligned with the work surface without gouging and they
also help the efficiency of the dust collection by the Spit vacuum cleaner AC 1600.
3 These brush bristles will wear with continued use.
The sanding plate cover should be replaced when the bristles are too worn to ensure
effective dust collection and stabilization of the sanding head.
4 4
Drywall sanding machine DWS 225
Carrying bag
Bail handle
L-hex wrench
4 straps for strapping the cable to the vacuum hose
Pair of spare auto stop carbon brushes
Instruction manual