SPIT DWS 225 Manual De Instrucciones página 9

Replace the cover
Unplug the machine (1).
Hold the sanding plate in one hand and with the other, using the L-hex wrench
(supplied) first break free the center bold clockwise (1/8 turn only).
Then only use the L-hex wrench to hold the center bolt from turning and spin off the
sanding plate counterclockwise (3).
Then, press the cover down against the spring and, by using snap-ring pliers, remove
the circlip which holds the sanding plate cover to the bracket (4).
4
Finally, carefully work the vacuum hose free and lift the sanding plate cover away.
Replacement is the opposite of removal. Don't forget the spring (5).
Install the vacuum cleaner hose
Unplug the machine (1).
5 Plug the vacuum cleaner hose bayonet mount into the swivel mount in the back of the
machine. Once the tangs of the bayonet mount are fully inserted in the slots, hold
the swivel mount from turning and turn the hose bayonet mount clockwise to lock (6).
Removal is the opposite of assembly.
The Spit vacuum cleaner AC 1600
6
Ensure that you have a dust bag installed in your vacuum cleaner which is approved
and rated for drywall dust.
WARNING: Failure to use an approved dust bag in your vacuum cleaner will
increase the level of airborne dust in the work area. Prolonged exposure to such
dust may cause respiratory harm.
Starting and stopping the tool
7
Make sure that the power circuit voltage is the same as shown on the specification
plate of the machine and that the switch is "OFF" (7) before connecting the tool to the
power circuit.
GB
5
5