Bracket Mounting - Bradley Express ELX Serie Manual Del Usuario

ELX-3
1

Bracket Mounting

Typical installation is shown. It may be necessary to repair the wall
after mounting. The fixture may not cover all of the wall modifications.
Mounting height per structural rough-in dimensions.
11⁵⁄₈"
(295mm)
10
Locating Notch
28"
(711mm)
Install the remaining trap cover brackets at the
C
locations defined by the horizontal line draw in
Step B and marked at 28" both to the left and right of
the center bracket. Secure the brackets to the wall
anchors using fasteners per the structural rough-in
requirement (supplied by installer). (3x)
3/2/2020
Install wall bracket to wall
A
per structural rough-in
dimensions. Check to
ensure the bracket is
level. Example anchor
locations shown.
Locating Notch
Measure down using the
center location notch on
B
the wall bracket. Draw a
horizontal line and mark 28"
locations to the right and
left of the center bracket.
Locating Notch
28"
(711mm)
Bradley • 215-1816 Rev. H: ECN 19-08-037F
Installation
11⁵⁄₈"
(295mm)