bloom Fresco Guia Del Usuario página 27

• Keep the high chair away from furniture,
walls, hot surfaces and liquids, window
covering cords, and electrical cords and
position the high chair away from furniture
when the chair is not being used at a table
with a tray removed.
• In compliance of ASTM F404 for the US
market and AS 4684 for the Australia
market, the comfort nest shall be installed
on the seat unit for highchair use with
children between 6 months and 3 years.
• In highchair mode the seat unit shall always
be adjusted to the vertical upright position.
Footrest Assembly and Footrest Adjustment
IMPORTANT!
• DO NOT use footrest as a step.
• Suitable for use up to 24 months.
– (#11 footrest) Slide in footrest until you hear
an audible click Check footrest is secured by
pulling it downwards.
– To remove footrest, press button located on
the end of the footrest attached to the seat
unit, whilst sliding the footrest out of seat unit.
– The footrest has three height positions. Press
the button on the back of the footrest, whilst
sliding footrest up or down to your desired
position. The footrest is locked into position
when you hear an audible click. Check
footrest is secured by pulling it downwards.
(refer to illustration c1)
To install seat pad
– follow "To install seat pad & Safety Harness
Assembly" in section B.
– Adjust the length of the harness straps until it
fits firmly around your child.
To install Safety Bar, Seat Pad & Safety
Harness Assembly
– (#10 safety bar) Insert the both end of the
safety bar into the slot locate on both side of
seat unit. You will hear an audible click. (refer
to illustration c4)
– Insert the loop on the end of the crotch strap
through the upper hole of the crotch strap
cover at the end of crotch bar, and then put
the loose end under the crotch strap cover.
Then slide the crotch strap cover into the seat
unit. The strap and buckle must not be twisted
or inverted. This will ensure correct locking of
the harness. (refer to illustration c5)
– To remove the safety bar, press and hold
the button under the two side domes, and
then press the side button on dome cap to
disengage the lock. And then press the button
on the crotch cover and remove from the seat
unit. (refer to illustration c4)
WARNINGS:
To avoid safety bar broken - do not hang
the safety bar freely with only the crotch bar
attached on the chair
Mini Tray Assembly
– (#05 mini tray) Latch the hook located on the
eng
7