bloom Fresco Guia Del Usuario página 28

eng
bottom of the mini tray onto the safety bar
whilst rotating the tray downwards.
– Lock the mini tray into position by pressing
down on the left and right arm of the tray.
You will hear an audible click. (refer to
illustration c7)
– To remove the mini tray, reverse the order of
assembly steps.
– The mini tray is dishwasher safe, and is made
of FDA compliant food contact grade plastic.
Food Tray Assembly
– (#06 food tray) Squeeze the left and
right trigger located under food tray
simultaneously, whilst sliding the food tray
onto the mini tray, then release triggers at
your desired setting. You will hear an audible
click. Check the food tray is locked in place
by attempting to pull it free of the highchair.
(refer to illustration c8)
– The food tray can be locked in two positions.
– To adjust the tray, pull the left and right side
triggers located under the tray simultaneously
whilst sliding the tray forwards or backwards.
Release triggers at the desired setting. You
will hear an audible click. Check the food tray
is locked in place by attempting to pull it free
of the highchair.
– To remove the food tray, reverse the order of
assembly steps.
– The food tray is dishwasher safe, and is made
of FDA compliant food contact grade plastic
and stainless steel.
NOTE: Always check the tray is securely locked
8
in place by attempting to pull it free of the
highchair.
WARNING:
The tray is not designed to hold the child in the
chair.
Seat unit height and Seat unit recline
– To adjust seat height, disengage the swivel/
height resistor. Lift both A & B trigger
simultaneously, whilst pushing downwards
or pulling upwards to desired height, then
release the triggers.
– In highchair mode the seat unit shall always
be adjusted to the vertical upright position.
– Adjust the seat unit to the vertical upright
position by pulling the handle on the rear
of the seat unit outward, then raise the seat
upwards to the highest position, then release
the handle. You will hear an audible click.
Check the seat unit is locked in position by
moving it. (refer to illustration c9)
NOTE: The seat unit can only be in most
upright position with the play tray or food tray
installed. (refer to illustration c10)
Section D: Comfort nest Installation
– (#09 safety harness, #08 nest pad) Put
shoulder straps through the nest pad slits at
the desired height setting.
– Put waist straps through the nest pad side
slits.
– (#04 seat unit, #12 storage compartment)