Pairing - ROTOR 2 IN PUWER Manual De Usuario

3. PAIRING

TM
3.a. ANT+ PAIRING
Connect your ROTOR 2INpower with any device that's ANT+™ compatible.
For a complete list of ANT+™ certified products, visit:
http://www.thisisant.com/directory/
Read the ANT+™ device manual for further instructions.
Pairing can be done both automatically or using the manual mode (recommended when other
ANT+™ power meters are close).
Before pairing ROTOR 2INpower with a monitor, make sure you are at least 10 meters (30 feet)
away from any other ANT+™ power sensor. This will prevent accidental pairing with another
power sensor.
The ROTOR 2INpower retains its "SENSOR ID" after charging or replacing the battery and will
remain properly paired.
3.a.1. ACTIVATION PROCESS
3.a.1.1. To minimize battery consumption, the system is activated by applying a force to the
pedals of at least 2.5 kg. Riding a few meters is sufficient.
3.a.1.2. Your ROTOR 2INpower is sending a radio signal and is ready to be paired and measure
data.
3.a.2.a. AUTOMATIC PAIRING
Once 2INpower is active and within two minutes of activation (2INpower enters sleep mode
after two minutes), push the "SCAN" button on your ANT+™ device at the ANT+™ Power
screen. The "SCAN" button is usually placed in the menu:
Settings\Bike settings\Bike profiles\"Your profile"\ANT+ Power.
Wait for confirmation from the monitor.
Pairing 39