Battery - ROTOR 2 IN PUWER Manual De Usuario

6. BATTERY

6.1. INSTALLATION AND SPECIFICATIONS
ROTOR 2INpower is powered by a Lithium (Li-ion) battery with 3.7 V of nominal tension.
Estimated riding time: 250 hours*.
When battery level is lower than 3.55 V, the computer device will show a "low battery" message. From
that moment, estimated riding time is 30 hours, and recharging is recommended. A complete charging
cycle takes approximately 4 hours in which the LED will blink until the battery is fully charged. The
battery's charge level can be checked with any computer or Bluetooth Smart / ANT+ compatible
device.
Battery can be fully recharged at least 300 times without being damaged, so it shouldn't be necessary
to replace the battery during the life time of the power meter. A special tool is required in case battery
replacement is needed. For that purpose, contact your ROTOR dis tributor and they will assist you.
*Tests performed in laboratory conditions. Fast mode consumption (only when connected to the Advanced
Training Mode with the User Software) is greater, reducing the hours of autonomous use.
6.2. BATTERY RECHARGING
6.2.1. Open the dust cover in the right crank. Do not use any tool or cutting object.
6.2.2. Connect the magnetic charger to the charging port in the right crank. After that, connect the USB
terminal to a power source.
44 Battery
TM TM