Manufacturer's Warranty; Indications Relatives À La Documentation - Hilti SF BT 22­A Manual De Instrucciones Original

Trouble or fault
The control switch
can't be pressed, i.e.
the switch is locked.
The power tool
doesn't run.
The tool doesn't
work and one LED
blinks.
The tool cuts out
while operating, the
4 LEDs on the bat-
tery display blink.
The battery runs
down more quickly
than usual.
The tool or battery
gets very hot.
9

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about
the warranty conditions.
Mode d'emploi original
1 Indications relatives à la documentation
1.1 À propos de cette documentation
• Lire intégralement la présente documentation avant la mise en service.
C'est la condition préalablement requise pour assurer la sécurité du
travail et un maniement sans perturbations.
12 Français
Possible cause
The switch-on interlock
is activated.
The battery is not fully
inserted.
Battery is discharged.
The overload cut-out
has been activated.
The overheating cut-out
has been activated.
Very low ambient tem-
perature.
The tool is overloaded
(application limits ex-
ceeded).
Action to be taken
▶ Push the switch safety
lock to the side (to the
left as seen from the
working direction).
▶ Push the battery in
until it engages with
an audible click.
▶ Change the battery
and charge the empty
battery.
▶ Release the control
switch and then press
it again.
▶ Allow the power tool
to cool down. Clean
the air vents.
▶ Allow the battery to
warm up slowly to
room temperature.
▶ Pay attention to the
power and perfor-
mance rating of the
product before using
it, i.e check its suit-
ability for the job on
hand. See "Technical
data" section.
2160456
*2160456*