Using The Machine; Chain Brake - GGP ITALY ME77 Manual De Instrucciones

10
EN
This product has accordingly been designed
with a ventilation hatch on the right side of the
surface of the cylinder cover to allow warm air to
be supplied to the engine and to thereby prevent
icing from occurring.
Under normal circumstances the product should
be used in the normal operating mode, i.e., in the
mode which it is set at the time of shipment.
However when the possibility exists that icing
may occur, the unit should be set to operate in
the anti-freeze mode before use.
To switch from "Normal" mode to "Anti-freeze"
mode (and vice versa) (Fig. 11):
1. Switch the engine off.
2. Remove the air filter cover (1) and the air filter
(2).
3. Remove the choke (3) from the cylinder cover
(4):

7. USING THE MACHINE

To respect people and the environment:
– Try not to cause any disturbance.
– Scrupulously comply with local regulations
and provisions for the disposal of waste
materials after sawing.
– Scrupulously comply with local regulations
and provisions for the disposal of oils,
petrol, damaged parts or any elements
which have a strong impact on the environ-
ment.
WARNING!
clothing when using the machine. Your deal-
er can provide you with all the information on
the most suitable
devices to guarantee your safety. Wear anti-
vibration gloves. All the above-mentioned
precautions do not however guarantee the
prevention of certain risks – i.e. Raynaud's
phenomenon or Carpal tunnel syndrome. For
operators who use this machine for pro-
longed periods, it is therefore recommended
to have periodic check-ups on the hands and
fingers.
If any of the above mentioned symptoms
should appear, please contact a physician
immediately.
HOW TO START - USE – STOP THE ENGINE / USING THE MACHINE
Always wear suitable
accident-prevention
4. Unscrew the screws (5) which secure the
cylinder cover in place (three screws inside
and one outside) and remove the cylinder
cover.
5. Use your fingers to press the anti-freeze cap
(6) on the right side of the cylinder cover and
slide it out from its seat.
6. Turn the anti-freeze cap (6) so that the
"SNOW" symbol is facing upwards and then
replace the cap.
7. Replace the cylinder cover and all the other
parts in their original position.
NOTE
anti-freeze mode at higher temperatures, this
may cause difficulties when starting the engine
and during use due to the incorrect engine
speed. Always check that the machine is
switched to normal mode (with the "SUN" sym-
bol facing upwards) if there is no danger of ice
forming.
DANGER!
unit generates an average sized electromag-
netic field, but it is not however possible to
exclude the possibility of interference on any
active or passive medical devices that opera-
tors may be wearing; this could be risky for
their health conditions. All those using med-
ical devices should always consult their GP,
or the device manufacturer, before using this
machine.
WARNING!
to use the machine for felling and delimbing.

CHAIN BRAKE

This machine comes with an automatic brake
that stops the chain when kickback occurs dur-
ing cutting.
This brake can be operated manually by pushing
the front guard forward. To release the brake,
pull the front guard towards the handgrip until
you hear a click.
WARNING!
the chain brake does not function correctly
and have it inspected by your dealer.
If the machine is used in
This machine's starter
It takes specific training
Do not use the machine if