Publicidad
Step 5- Attach Panel Clips Back posts
1. O n a flat surface place P- 4x4 Post on its side and position Panel Clips in
locations indicated in Figures 1 and 1A. Ensure Panel Clips are oriented
as shown in Diagrams!
2. Panel Clips should be placed in the centre of the post or the leading edge
of the clip should be 1 3/8" or 3.5cm away from the side of the post as
shown in Fig. 2.
3. With Panel Clips in place, mark screw holes with a pencil and pre-drill
holes with a 1/8" drill bit. (Not provided)
4. S ecure Panel Clips in locations indicated in figure 1 and 1A with S7- #8 x 1
1/2" wood screws.
56 1/4"
(142.9cm)
40"
(101.6cm)
(25.3cm)
4x
4x4 Post
P
Fig.1A
Top View
A
B
C
D
18x - Panel Clips
36x
#8 x 1 1/2" Wood Screw
S7
9
Fig. 2
1 3/8"
(3.5cm)
Pre-drill holes and secure with S7- #8 x
1 1/2" Wood Screws
Front View
Fig. 1
Publicidad
