Shark ION X40 IR140 Serie Manual Del Propietário página 6

MAINTAINING YOUR VACUUM
CLEANING THE FILTERS
To clean filters, rinse with water only to prevent damage from cleaning chemicals. Allow all filters to air-dry
completely for at least 24 hours before replacing them in the vacuum to prevent liquid from being drawn into
electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
FILTER COVER
FILTER
FRAME
PRE-MOTOR
FILTER
PRE-MOTOR FILTER
Remove cover and frame. Slide filter off frame.
Rinse with water. Air-dry completely for at least
24 hours before reinserting. Tap off loose dirt
between washes as needed.
ACCESSING BRUSHROLLS
Open the brushroll garage by sliding back the release
buttons. To close, insert the tabs on the lid into the
slots on the nozzle, then press down both sides.
s h a r kc l e a n . c o m
POST-MOTOR
FILTER
FILTER
COVER
POST-MOTOR FILTER
Remove cover and filter. Rinse filter with water.
Air-dry completely for at least 24 hours before
reinserting. Tap off loose dirt between washes
as needed.
CLEANING BRUSHROLLS
BRUSHROLL
Run scissors along the guide on the brushroll
to remove any string, hair, or debris.
MAINTAINING YOUR VACUUM
Securely close the garage door by clicking it in to place
on both sides.
NOTE: Failure to securely click garage door in place
on both sides will result in the brushroll indicator light
blinking green and the brushrolls will not spin.
CHECKING FOR BLOCKAGES
Turn off vacuum and remove battery.
Remove the hand vacuum and floor nozzle from
the wand and check the wand for blockages.
SOFT ROLLER
Pull out roller by the tab. Remove any string, carpet
fibers, or hair, and remove debris from the roller
housing. Wash the roller as needed, using only
water. Air-dry completely for at least 24 hours
before reinserting.
Reinsert roller by sliding it into the front of the
floor nozzle until it clicks into place.
Turn off vacuum and remove battery.
Remove the handheld vacuum from the wand
and check all intake openings to the dust cup.
s h a r kc l e a n . c o m