Publicidad
Idiomas disponibles
Idiomas disponibles
DOUBLE FLASH STROBE LIGHT MOD LE-106CH
Model LE-106CH is a special warning light which uses a Xenon lamp as source of light.
These lamps have been introduced into the modern special warning lights because of their greater
reliability and performance. The absence of moving parts and the high performance of this type
of lamp, have been the decisive factors which have contributed to their general acceptance.
This type of light has an electronic circuit which charges a capacitor and generates the
triggering of the lamp.
The LE-106CH strobe light has been approved by the ECE-R65 with the following homologation
marks:
Amber light A1-E9-00-1028
Blue light
The LE-106DCH is available with several functioning options.
(See page 18 and 19, "Connecting diagram")
CONTENTS
When the packing box is opened, check its contents and that all parts are in good condition.
Inside the packing box you should find:
- A special warning light
* AMBER LE-106CH model ref.2002311
or BLUE LE-106CH model ref.2002312
- An adaptable rubber base for fitting to the roof of the vehicle
- An accessories bag containing:
* Three 4,2x16 self-tapping screws
* Three 4,2x32 self-tapping screws
* Three M5x30 screws
* Three M5x16 screws
* Three flat washer
* Three spring lock washer
* Three 20 mm ring gaskets
* One rubber grommet
SAFETY INSTRUCTIONS TO INSTALLERS
- Before installing the equipment, read and understand all the instructions.
- In the electronic circuit there are high voltage points. DO NOT REMOVE THE COLOURED
LENS WHILST THE EQUIPMENT IS CONNECTED AND ONCE DISCONNECTED, DO NOT
REMOVE IT UNTIL TWO MINUTES HAVE PASSED.
- To properly install this light you must have a good understanding of automotive electrical
procedures and systems, along with proficiency in the installation and use of safety warning
equipments.
- Do not connect the positive wire to the battery until the installation has been completed.
Before connecting check that there is no short circuit to negative.
- When drilling into a vehicle structure, be sure that both sides of the surface are clear of
anything that could be damaged.
INSTALLATION
The light should be installed on the upper part of the vehicle in such a way that the base is
parallel to the ground and the beam of light is horizontally emitted.
This light can be installed in three different ways depending on the characteristics of the
vehicle.
B1-E9-00-1027
GB
16
Publicidad
