Federal Signal VAMA LE-106CH Manual Del Usuario página 21

DOUBLE FLASH STROBE LIGHT MOD LE-106DCH
* BLUE LE-106DCH model ref.2002314
"LAMP FAILURE DETECTION OPTION"
1- The "M-S" switch should be in "M" position.
2- Connect the feeding switch (red cable). The pilot of lamp failure will light (white cable).
3- If a lamp fails more than two serial shots, the internal relais of lamp failure will act deactivating
it. To disconnect the relais it is necessary to disconnect the feeding switch and to wait 10 seconds
before connecting it again.
4- When connecting the Low Intensity Switch (yellow cable), the light will work in Low Intensity.
Switching it on, the light works in High Intensity again.
"OPTION SYNCHRO + OPTION FAILURE OF LAMP"
The Synchro option allows that the flashes of the "Slave" unit works alternately with the
flashes of the "Master" unit.
1- The "M-S" switch of the "Master" light should be in position "M" and the "M-S" switch of the
"Slave" light should be in "S" position.
2- When connecting the feeding switch, the pilot of the lamp will light on.
3- If one of the lamps fails more than two serial shots, the internal relais of the same will act
deactivating the light. The pilot of lamp failure will. To close the relais it is necessary to disconnect
the feeding switch and to wait 10 seconds before connecting it again.
4- When connecting the switch of Low Intensity, the lights will work in Low Intensity. Opening the
switch, the lights work in High Intensity again.
LAMP REPLACEMENT LE-106DCH ( See Page 18)
20