Publicidad
Idiomas disponibles
Idiomas disponibles
2
These holes
should be
located here.
Follow the diagrams closely for this step. Be sure the parts are positioned as shown.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the
hole of the adjoining part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
- Fasten the TOP (C) to the LEFT END (B). Tighten the TWIST-LOCK
NOTE:
Be sure the finished edge of the LEFT END and long finished edge of the TOP are facing up.
Follow the diagram.
- Fasten the BOTTOM (D) and SHELF (I) to the LEFT END (B). Tighten the TWIST-LOCK
the BOTTOM and SHELF.
NOTE:
Be sure the three small holes in the BOTTOM are in the location shown. Be sure the surface
with TWIST-LOCK
is facing up. Follow the diagram.
101785
All manuals and user guides at all-guides.com
Finished
edge
LEFT
END (B)
Finished
edge
SHELF (I)
BOTTOM (D)
Surface with
TWIST-LOCK
FASTENERS
R
R
FASTENERS on the SHELF is positioned as shown and the finished edge
www.sauder.com/services
Tighten the FASTENER as tight
as possible after inserting the
dowel end of the FASTENER into
the hole of the adjoining part.
Long
finished
edge
TOP (C)
R
FASTENER (Refer to the enlarged diagram.)
R
FASTENERS in the LEFT END.
R
FASTENERS in
Publicidad
