Metra INST-WM-GMK01 Instrucciones De Instalación página 19

ISO DDIN radio provision
1. Slide the radio brackets into the radio housing,
aligning the holes in the radio housing to the
clips on the brackets. (Figure A)
2. Slide the radio into the completed
assembly, and then secure using the
screws supplied with the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra or AXXESS. Test
the radio for proper operation.
Radio housing &
bracket (a) shown
in illustration
(Figure A)
KIT ASSEMBLY
4. Secure the completed assembly into the
dash, and then reassemble the dash in
reverse order of disassembly.
5. Suzuki XL-7 only: Trim the top corners of
the radio housing. (Figure C)
Aura, Cobalt, G5, HHR, Sky, Vue: Cut and
remove the top mounting tabs from the
radio housing. (Figure D)
Radio housing & bracket (a)
shown in illustration
(Figure B)
(Figure C)
(Figure D)
Cut the two top holes off
REV. 6/8/2021 INST-WM-GMK01
19