Kit Assembly - Metra INST-WM-GMK01 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Slide the radio brackets into the radio
housing, aligning the holes in the radio
housing to the clips on the brackets.
(Figure A)
2. Attach the pocket to the lower section of
the radio brackets using the (4) #8 x 3/8"
Phillips screws provided. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket
assembly, and then secure it using the
screws supplied with the radio. (Figure B)
Radio housing &
bracket (a) shown
in illustration
(Figure A)
18

KIT ASSEMBLY

5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra or AXXESS. Test
the radio for proper operation.
6. Secure the completed assembly into the
dash, and then reassemble the dash in
reverse order of disassembly.
7. Suzuki XL-7 only: Trim the top corners of
the radio housing. (Figure C)
Aura, Cobalt, G5, HHR, Sky, Vue: Cut and
remove the top mounting tabs from the
radio housing. (Figure D)
Radio housing & bracket (a)
shown in illustration
(Figure B)
(Figure C)
(Figure D)
Cut the two top holes off
|
386.257.1187 MetraOnline.com