Metra INST-WM-GMK01 Instrucciones De Instalación página 6

(Figure E)
(Figure F)
6
DASH DISASSEMBLY
Chevrolet Malibu 2004-2007 (Cont)
5. Unclip and remove side panel from passenger side of dash with door open and
remove (2) 7mm screws from behind panel. (Figure E)
6. Remove (2) 7mm screws from bottom of glove box then open box and squeeze sides
together to open further and remove the remaining (4) 7mm screws. Unclip the black vent
cover under the glove box then unclip and remove entire glove box assembly. (Figure F)
7. Unclip and remove trim panel surrounding radio and climate controls. (Figure G)
8. Remove (4) 7mm screws securing the radio and (2) 7mm screws securing the
climate control. Unplug and remove the radio. (Figure H)
Continue to Kit Assembly
(Figure G) (Figure H)
Chevrolet Malibu 2008-2012
1. Unsnap and remove shifter trim. (Figure A)
Note: Start around shifter and be sure to pull down before back
because this panel slides up under the radio/climate panels .
2. Remove (2) 8mm screws from bottom of radio/climate panel.
3. Unsnap and remove the climate/radio panel and upper
vent trim panel together. They can be separated after
removal. (Figure B,C next page)
4. Remove (6) 8mm screws from radio and climate controls.
Continue to Kit Assembly
(Figure A)
386.257.1187
|
MetraOnline.com