Bremont 247 TI-GMT Manual Del Usuario página 4

CHRONOGRapH TIMING FUNCTION
Screw-down Push-button A
(unscrew to operate)
1 - START
2 - STOP
Screw-down Push-button B
(unscrew to operate)
3 - RESET to zero
Pressure must not be applied to both pushers
simultaneously. Pushers must be screwed
back in once used to prevent entry of water.
CHaNGING THE STRap
Your MODEL 247 TI-GMT is supplied with its own tool to allow the removal and
assembly of its strap which is retained in place using a bar and two threaded inserts.
REMOVING A STRAP
1. Ensure that the hexagon drive bit is
fully extended. This can be achieved
by holding the small end of the tool
and rotating the main body clockwise.
2. Locate the drive bit into the
threaded insert you wish to remove.
Rotate the main body anti-clockwise
to loosen and remove the threaded
insert. Support the strap when
removing to ensure that it isn't
damaged or is dropped. Repeat for the
opposite threaded insert, removing the
strap via the slots in the case lugs when
clear. Remove the bar from the strap if
required. Repeat for the opposing side
if required.