Specification; Troubleshooting - AKASO B70 Manual Del Usuario

⑩ Feedback: Write your feedback of this product.
Enter into the more setting, click "Feedback" to set.
• Firmware Info.: Check for the firmware update.
Enter into the more setting, click "Firmware Info" to set.
• Remove Device: Remove devices from this APP .
Note: After the device is deleted, the cloud storage service will be automatically released.
Please consider carefully.
If you need to add the camera by another account or return the product, please delete
the camera in the APP . Enter into the more setting, click "Remove Device".

SPECIFICATION

1080P Color Sensor
Image sensor
1/4CMOS
Min. illumination
0.1Lux(IR LED On) / F1.2
Shutter speed Auto
Lens 3.6mm
Angle of view 120 degree
Electronic(IR-CUT filter
Day & night
with auto switch)
Video
H.264
compression
16Kbps~2Mbps
Bit rate
Dual stream Yes
Image 1080P(1920*1080),
resolution VGA(640*480)
20
Backlight
Auto
balance
Brightness, contrast,
Image setting
chroma, saturation
Intelligent motion
Alarm trigger
detection
Network TCP/IP , UDP , DNS/DDNS,
protocols SMTP , UPNP ,DHCP ,,etc.
Wireless Wi-Fi, 802.11 b/g/n
iOS 7 up,
Supported
mobile phone OS Adroid 4.0 up
User authentication,
Security
software encryption
On-board
Built-in TF slot,
storage
up to 128GB
Operating - 68 °F to 122 °F
temperature (- 20 °C to 50 °C)
Color /
White / Black / metal
Material
Frame rate 25fps
White balance Auto
Shutter speed Auto

TROUBLESHOOTING

1. Why can't I add a device or fail to configure the network?
According to the status of the device indicator, you can determine the cause and solution
of the failure of the network connection.
① Before adding the device, ensure that the device is in red flashing state (2 times in
1 second). If the indicator status is abnormal, please reset the device to factory settings
(press and hold the device RESET button until you hear a beep) (The reset button
position of each product is different, but they are marked with "RESET").
② The device indicator does not turn blue or does not hear the beep.
A. Note that the screen of the mobile phone is aligned with the lens of the device in
parallel, and the distance is kept at about 15cm.
B. Try to adjust the distance between the phone screen and the device before and after,
and keep it for 2 seconds or so in each position.
C. Please check if there are any stains on the surface of the lens of the device.
D. Make sure the screen of the phone is clear, crack-free and non-reflective.
E. Use the other way of network connection.
③ The device indicator flashes blue quickly and does not turn constant blue.
A. device does not support 5GHz WiFi, please ensure that when adding device, the
phone is connected to 2.4GHZ WiFi.
B. WiFi password must be entered correctly, and there must be no special characters.
C. Note that the current WiFi network is smooth, it is recommended to try to restart the
router.
④ The device indicator light turns blue. And the APP can not find the device.
A. Try adding devices in other ways
B. If after repeated attempts, the blue light is still on and the device cannot be found.
Please contact customer service for technical assistance.
Power supply DC 12V/1A
Power
2W~5W
consumption
IR distance Night visibility up to 20m
21