Uline Н-1226 Instrucciones De Ensamblaje página 3

1
Bottom
Figure 1
6
Figure 2
Figure 3
PAGE 3 OF 12
Top
2
1
4
2
6
1
5
7
ASSEMBLY
ASSEMBLING MAIN PANELS
NOTE: Do not tighten bolts until
unit is completely assembled.
1. Locate and separate the left and right sides (2 and 7).
Identify the top of each panel. The top of each panel
has three holes instead of one.
2. Place back (1) on a protected flat surface so that
the flanges face upward.
3. Bolt left side (2) to the back (1) so that side flange
fits around back (using 7 bolts and nuts - nuts to
the inside). Do not use bottom 2 holes; these will be
used for attaching legs in step 7. (See Figure 1)
4. Bolt shelf (4) to back and side. Attach coat hooks (5)
to the left side and back panel:
• Side – 3rd and 4th holes below shelf (6th, 7th holes
down from top).
• Back – 2nd and 3rd holes below shelf (5th, 6th holes
down from top). (See Figure 2)
5. Attach top and bottom (6) to side and back as
shown.
6. Bolt right side (7) to the back so that side flange
fits around back. Attach side to top, bottom and
shelf. Attach remaining coat hook to the right side.
(See Figure 3)
0821 IH-1226