Uline Н-1226 Instrucciones De Ensamblaje página 4

3
Figure 4
Figure 5
PAGE 4 OF 12
ASSEMBLY CONTINUED
9
8
1-800-295-5510
uline.com
7. Insert legs (3) into the corners between the bottom
and the side. Bolt the leg to the side using 2 bolts
and nuts per leg. (See Figure 4)
8. Place door and frame assemblies (8 and 9) over
the locker body. Make sure body sides are inside
the frames, not between the frames. Attach top to
frame header and the bottom to frame sill using
one bolt each. Finish attaching the frame using 16
bolts and nuts. (See Figure 5)
9. Stand unit upright and place in desired location.
10. Check and tighten all bolts.
11. To attach coat rod, place non slotted end of coat
rod (10) over projecting tab of top left coat hook.
Slide the slotted end of coat rod over the projecting
tab in the right coat hook and turn 90 degrees to
secure it.
SECURING UNITS
1. Anchor units to wall or floor. Unanchored units may
fall over if not secured. (Units standing back to back
should be bolted together.)
CAUTION: Care must be taken to assure
that lockers are set plumb and true before
anchoring.
2. If units are not pre-numbered, optional number
plate (11) may be attached with two push plugs (12).
0821 IH-1226