5
15
13
16
Figure 7
Figure 8
17
Figure 9
PAGE 5 OF 15
ASSEMBLY CONTINUED
18
3. Place the door and frame assembly (15 and 16) over
the locker frames. Make certain the body sides are
inside the frames, not between the frames. Attach
top to frame header and bottom to frame sill (one
bolt each). Bolt the side of the door frame (15) and
side for horizontal section (13) together, from left to
right (2 bolts each). Bolts will be shared with the door
on either side. Leave bolt holes open on the outside
frames. These holes are needed to join the units
together. (See Figure 7)
JOINING UNITS TOGETHER
1. Bolt the horizontal frame to the two vertical frames as
shown in Figure 8 (use 5 bolts and nuts per side). Do
not use the center bottom hole on either side; these
will be used for attaching the coat rod. Finish bolting
the door frame (7) to the body of the vertical units by
adding the top bolts. The inside frame will share the
bolt with the horizontal unit. (See Figure 8)
2. With the help of a second person stand unit upright.
3. Slide coat rod brackets (17) over the coat rod (18).
From left to right, bolt coat rod brackets to the bottom
of the horizontal frame. (See Figure 9)
4. Move to desired location. Check and secure all bolts.
SECURING UNITS
1. Anchor units to wall or floor. Unanchored units may
fall over if not secured. (Units standing back to back
should be bolted together.)
CAUTION! Care must be taken to assure
that lockers are set plumb and true before
anchoring.
2. If units are not pre-numbered, optional number plate
and plastic covers (9) may be attached with two push
plugs (10). (See Door Detail on page 2.)
1-800-295-5510
uline.com
1120 IH-2489