Troubleshooting Guide - CARE Runner-20 Manual De Instrucciones

Do not put too much silicone on the deck. Excessive lubricant may cause slippage of the belt on the rollers.
TROUBLE SHOOTING
TROUBLE SHOOTING GUIDE
SYMPTOM
Scrambled digitalis on
console LCD
Show E1
CAUSE
a. No power to treadmill
b. Console wire connector not
connected or incompletely
connected
c. Overload protection is activated
Damaged console
a. RPM sensor problem
b. Senor wire not connect to
controller or improper connection c.
Motor wire not connected
d. Console wires not connect properly
e. Controller damaged
f. Overload protection is activated
SOLUTION
Check the on-off switch
Turn off, then turn on power.
Push START,
Check all of connected wires,
if still not illuminated, a service
is required
Check the lubrication, running
belt tension, turn off, then
turn on power