Care And Cleaning; Replacing The Batteries - Braun ThermoScan Plus IRT 3520 Manual Del Usuario

Care and cleaning

The probe tip is the most delicate part of the thermometer.
It has to be clean and intact to ensure accurate readings.
If the thermometer is ever accidentally used without a lens filter, clean
the lens as follows:
• Hold the appliance with the probe tip facing down to prevent liquid
from entering the probe tip area. Very gently wipe the surface with
a cotton swab or soft cloth moistened with alcohol.
• After cleaning, allow at least 45 minutes drying time before reat-
taching a new, clean lens filter and taking a temperature.
If the probe tip is damaged, contact Braun.
Use a soft, dry cloth to clean the thermometer display and exterior. Do
not use abrasive cleaners. Never submerge the thermometer in water
or any other liquid.
Store thermometer and lens filters in a dry location free from dust and
contamination and away from direct sunlight. The ambient temperature
at the storage location should remain fairly constant and within the
range of 50 °F to 104 °F (10 °C – 40 °C).
Always keep cleaning solutions and rubbing alcohol away from
children.

Replacing the batteries

The thermometer is supplied with two 3 V lithium batteries
(CR 2032/DL 2032). Insert new batteries when the battery
symbol appears on the display.
Using the tip of a ball-point pen, press the battery door lock to open
the battery compartment. Remove the batteries and replace with new
batteries, making sure the poles are in the right direction.
Slide battery door back in until it snaps in place.
11