Meta System METABLUE2 Manual De Instrucciones página 7

All manuals and user guides at all-guides.com
Introduction
EN
Dear Customer,
Before you start reading the operating instructions on the following pages, we would
like to congratulate you for choosing MetaBlue. It is our pleasure to give you some
general indications that you should find useful for getting to know how your new hands
free system works.
MetaBlue is a hands free appliance that uses Bluetooth technology.
The main reason for the creation of Bluetooth technology is its capacity to enable
dialogue and interaction between different appliances (telephones, printers, notebooks,
PDA, HiFi systems, TVs, computers, PCs, mobile phones, electrical appliances, hands
free systems...) without the need for wires to connect things generally known as
wireless together, provided the various paired appliances are located at a distance (or
range) of no more than 5 m from one another.
Wireless refers to the type of communications, to monitoring and to a series of controlling
systems where the signals travel through space and not along wires or transmission
cables. In a wireless system, transmission mainly takes place by radio frequency (RF).
Bluetooth technology was, therefore, specifically designed so that small appliances
can communicate with one another without wires. The key concept that inspired this
technology was that of completely eliminating the wires needed for communications
between appliances. MetaBlue is classified as Bluetooth 1.2, class 2.
Operating modes
The way the system operates is described below.
Always refer to the operating manual for your mobile phone for pairing and recognition
procedures.
The system is operational when the dashboard is switched on, unless the dashboard
is switched off when a telephone call is being taken. In this case, the system will
remain operational so the call can continue for a maximum of 10 minutes more.
Any activity involving interaction with your mobile phone must be done when the vehicle
is not in motion.
The LED identifies the various stages of activity by changing its status accordingly when
the dashboard is on.
• Fast flashing (1sec): the system is searching to pair up to a telephone.
This phase lasts 60 sec. at most, after which the led goes out and remains off.
• Lit without flashing: the system is connected up to a telephone.
Pressing the button will result in a tone being heard through the speaker, regardless
of the operating status of the system.
Pairing
Pairing: procedures enabling the reciprocal identification between the mobile phone
and the hands free set and enabling subsequent recognition.
In order to use the hands free set, the telephone and the hands free set must be
paired together.
7