nania BEONE Universal Manual De Instrucciones página 13

• Do not use load-bearing contact points other than those described in the
instructions and marked on the restraint system.
• Always give preference to rear seats, even if the highway code allows in-
stallation at the front.
• Always make sure that the car seatbelt is fastened.
• Always check that there is no food debris or other such matter in the buck-
le.
• In winter take care not to secure the child in with clothes that are too
bulky.
Your Group 0+
From 0 to 13 kg
1. Shell
2. Cover
3. Shoulder strap
4. Ergonomic handle
5. Sun canopy
6. Support pillow
7. Belt pad
8. Lap belt guide (x2)
9. Harness buckle
10. Harness release button
11. Crotch strap
12. Adjustment strap
13. Diagonal belt guide
TS. Travel system adapters release button (x2)
In-car installation
WARNING ! Do not install your Group 0+ seat on the front seat of a vehicle
fitted with an AIRBAG. Always position your Group 0+ seat facing rearwards.
Place the child seat on the front or back seat of your vehicle, always facing
rearwards, with the handle in the vertical position (3).
Buckle the belt (4).
Pull out the seat belt and pass the lap section through the side guides
(6). Pull and pass the diagonal section of the belt behind the car seat, and
slide it into the guide at the back of the shell
not twisted and stretch it as tightly as possible (9).
(2)
(7) (8). Ensure that the belt is
User guide - EN
(5)
13