INFOSEC UPS SYSTEM XP Pro evolution 1000 VA Guia Del Usuario página 9

All manuals and user guides at all-guides.com
SYMPTOM
1. Battery missing
No LED display on
2. Faulty battery
the front panel.
3. Power switch was not
pressed for at least 5
seconds
Alarm buzzer beeps
continuously when 1. UPS overload.
AC supply is normal.
1. UPS overload or the
connected equipment is
defective.
In the event of
power failure, 2. Flat battery.
reduced backup
time.
3. Battery defect due to the
high temperature of the
operating environment, or
improper operations.
1. The software is not
properly installed
The communication
is lost between the
UPS and the
2. The cable is not properly
computer
connected
1. The circuit breaker is
broken
Mains power normal
but the UPS is not
2. Power cord is lost.
working.
3. No mains power supply or
UPS is not on.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec-ups.com
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 10 06 04 206 10
POSSIBLE CAUSE SOLUTIONS
1. Charge battery up to 10
hours
2. Replace with the same
type of battery.
3. Press and hold power
switch for at least 5 seconds.
1. Verify that the load
matches the UPS capacity.
Remove any non-critical load
e.g.: printer. Stop and restart
the UPS.
1. Remove any non-critical
load.
2. Recharge the battery 10
hours or more.
3. Replace with the same type
of battery.
1. Check the setting of the
software
2. Check if th RS 232 cable or
USB cable are firmly
connected on the
corresponding communication
port of the computer.
1. Replace with the same type
of fuse
2. Reconnect the power cord
properly
3. Check the power supply
9