Nolan X-lite X-801 Instrucciones De Utilizacion página 10

1.4.3 Slide the visor until the visor locks into place.
1.4.4 Repeat the steps above on the other side of the helmet.
Important!
Pull the visor up and down several times to make sure that it
works properly.
1
B1
B2
1.5 Adjusting the visor (fig. 3)
The visor mechanism is equipped with a visor clearance take-up
system that ensures that the visor is pulled down and effectively
against the window trim. This is why the mechanism's support
has an upper and lower reference tooth.
The helmet is delivered with a correctly adjusted system. When
using the helmet, regularly check that the visor adheres perfectly
and is in line with the lip seal of the window trim when it is pulled
down all the way.
If this is not the case, proceed as follows:
1.5.1 Disassemble the visor (see section 1.3) and check in
which position of the upper reference A1 and lower refer-
ence A2 teeth (Fig. 3) the mechanism is located;
2
B1
B2
- 16 -
1.5.2 Loosen the two screws B1 and B2 (Fig. 4) on the visor
mechanism using a 2.5 mm Allen screw wrench.
1.5.3 Lift the mechanism from its support and move it forward
or backward according to the adjustment to be made.
Then lower the mechansim into its support so that upper
A1 lower A2 adjustment teeth are in the same position.
1.5.4 Tighten both screws B1 and B2.
1.5.5 Repeat steps 1.5.2, 1.5.3 and 1.5.4 on the other side of
the helmet.
1.5.6 Mount the visor (see section 1.4)
1.5.7 Check contact between the visor and the sealing.
Important!
- Pull the visor up and down several times to make sure that it
works properly.
- Do not remove the visor pull up/down mechanism from the shell.
- If they should fail or be damaged, contact an authorized Nolan
retail shop.
3
A1
B2
B1
A2
- 17 -