Warranty Registration; Return Process - Heatworks MODEL 1 Manual Del Usuario

7) Components/accessories not compatible with or not
intended for the unit are used with the MODEL 1.
8) This unit is used in an unapproved scenario such as,
but not limited to, as fish tank water heater, to heat
pools or spas, with a non-compatible AC/DC converter, if
under-sized for the intended application, etc. Please
contact Manufacturer before using the MODEL 1 in any
alternative scenarios so not to void your warranty.
9) The inlet / outlet is connected to any tap or fitting
other than those specified.

WARRANTY REGISTRATION

In order to activate your warranty, you must register
your unit. If you do not activate your warranty, your
MODEL 1 will be covered from the date it was
manufactured. Warranty registration can be accessed
through our website, www.myheatworks.com.
For more information, please visit www.myheatworks.com.
All manuals and user guides at all-guides.com
Subject to the terms and conditions set forth in the
limited warranty found on page 15, if the MODEL 1
Water Heater fails or leaks because of defects in
materials or Manufacturer's workmanship during the
applicable warranty period, Owner should contact
Manufacturer for a Returned Merchandise Authorization
(RMA). No returns will be accepted by Manufacturer
without an RMA number and Manufacturer assumes no
responsibility for a water heater returned without an
RMA number. Water heaters should be wrapped and
packaged securely to avoid shipping damage. The
OWNER will be responsible for shipping costs of the unit
in question from Owner to Manufacturer, as well as any
reinstallation costs. All shipments of the MODEL 1 Water
Heater from the Manufacturer to the Owner to replace a
defective unit shall be made via normal ground
transportation. If expedited shipment or insurance is
required, these can be provided at an additional cost.
11

RETURN PROCESS

17