Maintenance And Cleaning; Technical Assistance - VITO PRO-POWER VIMLSF12A Manual De Instrucciones

The control and safety devices installed in the power
tool must not be removed or inhibited.
The following precautions and procedures should also
be followed to avoid accidents:
▪ When using the oscillating multi-tool, place yourself
in a stable position and always keep your balance.
Hold the appliance firmly to ensure continuous
operation and withstand unexpected situations;
When the accessory jams, switch the power tool off
immediately.
▪ Make sure that the ventilation slots are not blocked
while operating the oscillating multi-tool. Do not
place any objects over the slots;

Maintenance and cleaning

Before performing cleaning, adjusting, repairing and
maintenance works, remove the battery from the
power tool.
Replace worn out or damaged parts immediately, so
that the power tool is always in a safe operating
condition.
Cleaning:
Always keep the power tool clean and dry, free of oil,
lubricants or grease. Clean all power tool components
and accessories after each use.
Do not use aggressive cleaning products. These
products may damage
compromising the safe operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out; all other works must be
performed by an official dealer.
26
plastics and metals,
Keep all nuts and screws well tightened in order to
ensure a safe operation.
If any components or safety devices are removed for
maintenance works, they must be repositioned
immediately.
Use only VITO-approved tools for this appliance or
technically identical parts. Not doing so may result in
personal injuries or damages to the oscillating multi-
tool. In case of doubt, lack of knowledge or resources,
you should contact an official dealer.

Technical assistance

Your oscillating multi-tool should only be serviced by
the manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.