Care, Maintenance And Disposal; Declaration Of Conformity; Warranty Terms - VITO PRO-POWER VILR800 Manual De Instrucciones

EN
- Keep the tool moving at all times.
- The movement of the belt sander
should be at a constant pace. This
guarantees an equally distributed
abrasion.
The belt sander is also applicable
to removing rust from steel or paint
and lacquer residues. However,
please abide by the following
advice:
- A sanding band that has been used
to work on metals, should not be
used to work on other materials.
- In particular, when sanding
lacquer residues these may melt
and smear across the surface of the
material and of the sanding band.
Worn out, damaged or torn sanding
band should not be used, as they
may damage the material. Therefore
replace the sanding bands in time.
Sandpaper may be found in various
grain sizes. The smaller the number
of graining, the finer the grain size.
The spectrum ranges from 40 (very
fine) to 280 (very rough).
Various types of wood require
different types of sandpaper. wood
I soft wood (such as pine, larch
or spruce) Up to 220 Fine pored
wood (such as beech or acorn)
120 to 150 The sand paper should
be stored at room temperature and
relatively low moisture.
Significant deviations from this, can
cause deformation of the material,
drying out, or softening of the
adhesive agent.
12
CARE, MAINTENANCE AND
DISPOSAL
Pull the power plug before doing
any care or maintenance work.
Care
- Clean the device regularly with a
moist cloth and soft soap (remove
dust, splinters, etc.)
- We recommend that you clean the
device after every use.
- Do not use any detergents or
solvents, as these may corrode the
plastic components of the device.
Make sure that no water can enter
the device.
Maintenance
There are no parts of the device that
the customer should maintain or
repair him/herself.
DECLARATION OF
CONFORMITY
We declare under our exclusive
responsibility, that the product
belt sander, with code VILR800,
meets the following standards or
standardization documents:
EN 60745-1:2009+A11:2010,
EN 60745-2-4:2009+A11:2011,
EK9-BE-88:2014,
EN 55014-1:2016/+A1:2009
/+A2:2011, EN 55014-2:1997/+A1:
2011/+A2:2008, EN 61000-3-
2:2014 and EN 61000-3-3:2013,
according to the determinations
of the directives:
2014/30/EU - Electromagnetic
Compatibility Directive;
2006/42/EC - Machinery
Directive;
2011/65/EU - RoHS Directive;
2000/14/EC - Sound power level
guaranteed: LwA: 94 dB(A).
- Sound power level mesured: LpA
83 dB(A).
S. João de Ver,
15th of December of 2017.
Central Lobão S. A.
Responsible for the Technical File

WARRANTY TERMS

The warranty of this machine is two
years from the date of purchase.
You should, therefore, keep your
proof of purchase during this period
of time. The warranty covers any
manufacturing defect in material or
operating, as well as parts and work
17
needed for their recovery.Excluded
from the warranty the misuse of the
product, any repairs carried out by
unauthorized persons (outside the
service center of the brand VITO)
as well as any damage caused by
the use of it.