Electrical Installation; Grounding Instructions - MADER LJ1500-24 Manual Del Usuario

overspray accumulation on the compressor.
18.When spraying or cleaning with solvents or
toxic chemicals, follow the instructions provided
by the chemical manufacturer.
ASSEMBLY
RUBBER FOOT ASSEMBLY
1. Insert bolt through hole in rubber foot (See
Figure 1).
Figure 1
2. Insert bolt into hole on front leg of tank..
3. Place two washers onto bolt then tighten nut.
WHEEL ASSEMBLY
Fit the wheels shown in Figure 2.
Figure 2
Note: with the compressor comes an air filter to
put on the head, for that you have to remove the
cap that is on the head and screw the air filter
INSTALLATION
LOCATION
It is extremely important to install the compressor
in a clean, well ventilated area where the
surrounding air temperature will not be more than
100°F.
A minimum clearance of 18 inches between the
compressor and a wall is required because objects
could obstruct airflow.
▲CAUTION!
compressor air inlet near steam, paint spray,
sandblast areas or any other source of
contamination. This debris will damage the
motor.

ELECTRICAL INSTALLATION

▲WARNING!
electrical connections should be performed by a
qualified electrician. Installation must be in
accordance with local codes and national
electrical codes.
▲CAUTION!
Never use an extension cord
with this product. Use
additional air hose instead of
an extension cord to avoid
power loss and permanent motor damage; Use
of an extension cord voids the warranty.

GROUNDING INSTRUCTIONS

1. This product is for use on a nominal 120-volt
circuit and has a grounding plug that looks like the
plug illustrated in Fig.3.Make sure the product is
connected to an outlet having the same
configuration as the plug. This product must be
grounded. In the event of an electrical short circuit,
grounding reduces risk of electrical shock by
providing an escape wire for electric current. This
product is equipped with a cord having a
grounding wire with an appropriate grounding
wire with an appropriate grounding plug. Plug
must be plugged into an outlet that is properly
installed and grounded in accordance with all
local codes and ordinances.
3
Do not locate the
All wiring and