Publicidad
Idiomas disponibles
Idiomas disponibles
Presetting Multiple Timing Programs
Each preset pad can be programmed to perform four
heating operations.
1.
Follow Steps 1, 2 and 3 of "Presetting Times and
Power Levels".
2.
To preset heating time for Program 1, press number
pads. Pad number remains in display and new
heating time appears.
3.
Press appropriate power level pad to heat at lower
power level or to hold. For example, to heat on
medium high, press MED HI pad. "MED HI" appears
in display.
4.
Press TIME ENTRY to advance to Program 2. "P2"
will be displayed for a second then current heating
time displays.
5.
Enter instructions for Program 2 by following
Steps 2 and 3. (To use only two programs, go to Step
8, check programs and press START.)
6.
Press TIME ENTRY to advance to Program 3. "P3"
displays for a second then current heating time is
displayed. Follow steps 2 and 3 above. (If using only
3 programs, go to Step 8, check programs and press
START.)
7.
Press TIME ENTRY to advance to Program 4. "P4"
displays for a second then current heating time is
displayed. Follow steps 2 and 3 above.
Deactivating a Number Pad
A hidden disable/enable pad located on control panel
allows programmer to deactivate unneeded number pads.
1.
Follow Steps 1 and 2 of "Presetting Times and
Power Levels".
2.
Press desired number pad to deactivate. Pad
number, heating time and power level (if other than
full power) appears.
3.
Press hidden disable/enable pad located directly
across from pad number 1 and directly underneath
left two digits in display. Four "d's" appears. This
verifies number pad is deactivated (see figure 2).
4.
Press START to lock program into oven memory. "P"
appears.
When deactivated pad is pressed in
operation mode nothing happens.
All manuals and user guides at all-guides.com
8.
9.
10. Repeat above procedure to preset other pads.
11. To exit programming mode press RESET or
3
To review oven programming, press TIME ENTRY
until "P1" briefly in display. Readout displays Program
1. Press TIME ENTRY again to view Program 2
instructions. Repeat for Programs 3 and 4, if used.
Press START to lock program into oven memory.
"P" appears in display.
close oven door. "READY" displays.
Multiple Timing Programming Summary
1.
Open oven door.
2.
Press pad 1 for 15 seconds.
3.
Press pad to be changed.
4.
Press new heating time and power level (if
applicable) for Program 1.
5.
Press TIME ENTRY.
6.
Enter instructions for Program 2.
7.
Press TIME ENTRY.
8.
Enter instructions for Program 3.
9.
Press TIME ENTRY.
10. Enter instructions for Program 4.
11. Press TIME ENTRY to advance to Program 1.
Continue to press TIME ENTRY to check oven
programs.
12. Press START to lock in program to oven memory.
13. Press RESET or close oven door.
figure 2
Publicidad
