Publicidad
Idiomas disponibles
Idiomas disponibles
5.
To deactivate additional number pads return to
Step 2.
6.
To exit programming mode press RESET or close
oven door. "READY" is displayed.
7.
To reactivate number pad follow above steps.
When disable/enable pad is pressed for deactivated
pad four "d's" will disappear and "0" will appear in
display. Pad may be programmed.
Changing the Optional Programs
1.
Open oven door. "READY" displays.
2.
Press pad number 1 for 15 seconds. After
15 seconds, beep will sound and "P" displays.
3.
Press hidden disable/enable pad located
directly across from pad number 1 and directly
underneath left two digits in display (see figure 3).
All manuals and user guides at all-guides.com
Reviewing Preprogrammed Heating Times
This feature allows review of memory programs. To
correct mistake or reprogram a pad see "How to Preset
Multiple Timing Programs" section on page 3.
1.
2.
3.
4.
5.
6.
7.
If oven is being used for first time "OP:11" will display. OP
represents optional program mode; the first number
represents pad number and the second number represents
functions currently selected for pad (see figure 3).
4.
5.
6.
7.
8.
figure 3
4
Open oven door. "READY" appears in display.
Press TIME ENTRY pad for 15 seconds. After 15
seconds, beep will sound and "P" displays.
Press desired pad to review. Pad number, heating
time, and power level chosen for Program 1 displays.
Press TIME ENTRY to continue to review programs
2, 3 and 4. "P2", "P3" or "P4" (depending upon which
program reviewing) displays for a second, then current
programmed heating time and power displays.
Press START. "P" displays.
To review additional programmed pads return to
Step 3.
To exit after reviewing program press RESET or
close oven door. "READY" displays.
To change factory-set option press pad
corresponding with desired function. See chart on
page 5 for explanation of function options for each
pad number. In figure 3 example, to prevent heating
time from being changed while the oven is operating
press Pad 0 "OP:10" will be displayed.
Press START to lock function into oven memory.
"OP:21" or "OP:20" display. Change optional program
for Pad 2, if desired.
Advance to any optional program by pressing
START.
To change additional optional programs return to
Step 4 and 5.
To exit optional program mode press RESET or
close oven door. "READY" displays.
Publicidad
