For Your Safety - Würth SOLAR II Manual De Instrucciones

GB
Please read and comply with these instructions prior to the initial operation of your
appliance.
Retain these instruction manual for future reference or for subsequent possessors.
Warning
Read & Understand All Instructions Before Using.
Auto-Darkening welding helmets are designed to protect the eye and face from sparks, spatter
and harmful radiation under normal welding conditions. Auto-Darkening filter automatically changes from a
light state to a dark state when an arc is struck, and it returns to the light state when welding stops.
The Auto-Darkening welding helmet comes assembled. But before it can be used, it must be adjusted to fit the
user properly. Check battery surfaces and contacts and clean it if necessary. Verify if the battery is in good
condition and installed properly. Set up for delay time, sensitivity and shade number for your application.
The helmet should be stored in dry, cool and dark area and remove the battery, when not using it for a long
time.
Warning
This Auto-Darkening welding helmet is not suitable for laser welding and oxyacetylene welding/cutting
■
processes.
Never place this helmet and Auto-Darkening filter on a hot surface.
■
Never open or tamper with the Auto-Darkening filter. Toughened mineral filter oculars shall only be used in
■
conjunction with a suitable backing ocular.
This Auto-Darkening welding helmet will not protect against severe impact hazards, including grinding discs.
■
This helmet will not protect against explosive devices or corrosive liquids.
■
Don't make any modifications to either the filter or helmet, unless specified in this manual. Don't use
■
replacement parts any other than those specified in this manual. Unauthorized modifications and
replacement parts will void the warranty and expose the operator to the risk of personal injury.
Should this helmet not darken upon stiking an arc, stop welding immediately and contact your supervisor or
■
your dealer.
Don't immerse the filter in water.
■
Don't use any solvents on the filter screen or helmet components.
■
Use only at temperatures: -10°C ∼ +55°C (+14°F ∼ +131°F).
■
Storing temperature: –20°C ∼ +70°C (–4°F ∼ +158°F).
■
Protect filter from contacting with liquid and dirt.
■
Clean the filter surface regularly; don't use strong cleaning solutions. Always keep the sensors and solar
■
cells clean using a clean lint-free tissue.
Regularly replace the cracked/scratched/pitted front cover lens.
■
Never try to open the filter cartridge.
■
The materials which may come into contact with the wearers skin, can cause allergic reactions in some
■
circumstances.

For Your Safety

Safety Warnings - Read Before Using
11