Recording Chases - TECshow NAVIGATOR 3+ Manual De Usuario

scene or the Blackout button to bring all output
to a blackout state.
4. Repeat steps 2 & 3 to manually playback addi-
tional scenes.
Auto Trigger
1. Press the AUTO/Del button, the Auto Trigger
indicator light will illuminate in the LED display.
This indicates you that you are now in the Auto
trigger mode.
2. Press the Bank UP/DOWN buttons to select a
desired scene bank, 1-30, for automatic play-
back. All eight scenes in the selected scene
bank will sequence.
3. At any time, you can adjust the Speed and
Fade fader to the adjust your scene sequence
playback state. You can also press the Tap/Disp
button twice to establish a sequence rate. The

13. RECORDING CHASES

This product has 12 programmable chases. Each of
which can store up to 240 scenes/steps. Please see
the below instructions for chase setting.
1. Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display flashes. Once the
indicator is flashing, record mode is engaged
and you may release the Program button.
2. Select a Chase # button, 1-12, that you wish
to record to. The relevant Chase LED should
illuminate.
3. Using the BANK UP & DOWN buttons, select
the scene bank, 1-30, that contains the scene
you want added to your chase. You can view
the scene banks in the LED display by referring
to the furthest two digits to the right. You can
also set your scene using the eight Channel
faders, joystick, or Channel Bank button on the
P. 10
Tecshow Navigator 3+ | English version
rate will be determined by the tempo at which
you press the Tap/Disp button. Pressing the
Auto/Del button again will disengage automatic
playback mode.
Audio Trigger
1. Press the Music/Rec button, the Audio Trigger
indicator light will illuminate in the LED display.
This indicates you that you are now in the Audio
trigger mode.
2. Press the Bank UP/DOWN buttons to select a
desired scene bank, 1-30, or a chase # button,
1-12. The selected scene bank or chases will trig-
ger to audio via the internal microphone or line
level input if connected. Pressing the Music/Rec
button again will disengage audio mode.
y if desired. The Channel Bank button should
be used to switch between channel banks 1-8,
9-16, 17-24 and 25-32.
4. PRess the MIDI/REC button to record the chase
step. All LES´s will flash three times to confirm
that the chase step was recorded.
5. Repeat steps 3 & 4 to record additional steps.
6. Once you've recorded all of your steps, press
and hold down the Program button for approx-
imately 2 seconds to exit. A fjashing Blackout
indicator, in the LED display, is indicative that
you are out of program mode.
Recording A Bank Of Scenes To A
Chase
1. Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display flashes. Once the