Starting And Stopping - Bosch AMR 32 F Instrucciones De Servicio

All manuals and user guides at all-guides.com
F016 L70 452 - Vorderseite.book Seite 3 Dienstag, 14. November 2006 2:20 14
For products not sold in GB: WARNING: For
B
safety, it is essential that the mains plug 4 attached
to the product is fitted to the power supply cable 13.
The couplings of connection leads must be pro-
tected against splashes and the coupling sockets on
the leads must be made of rubber or coated with rub-
ber.
Fixing means for the connection leads must be used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Centre.
Products sold in GB only: Your mower is fitted with
an approved 13 A (BS 1363/A) electric plug and is
protected by a 13 A fuse (ASTA Approved to
BS 1362).
If the fitted plug is not suitable for your socket out-
lets, it should be cut off and an appropriate plug fitted
in its place by an authorized customer service agent.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be inserted
into a 13 A socket elsewhere.
Assembly
Fix the handle bottom 6 to the body of the lawn-
A
raker using pivot pins 12. Ensure that the pivot cov-
ers 11 are fitted to the handle bottom 6.
Attach the handle top 1 with the bolts and the wing
nuts to the handle bottom 6.
Note: Ensure that the cable clips supplied are used
to fix the cable to the handle.
Attach cable to cable restraint 5 ensuring that
B
sufficient cable slack is available.
Grassbox/bag
Attach/remove the grassbox as shown.
C
Ensure the cables are not trapped when folding/un-
folding top handles. Do not drop the handles.
14 • F016 L70 452 • 06.11
Adjusting the Cutting Height
D
The lawnraker can be set to several operating
heights. For this purpose,
lever 9 outward then
sired raking height while supporting the weight of the
lawnraker with the other hand.
Depending on grass height and conditions set
scarifying/raking height as shown:
– tougher material
– lighter material

Starting and Stopping

E
The tines continues to rotate for a few sec-
onds after the machine is switched off. Al-
low the motor/tines to stop rotating before
switching "on" again.
Do not rapidly switch off and on.
To aid starting push handle down to lift front
wheels.
Starting:
Press and hold the safety button 3.
Squeeze the switch lever 2 towards the han-
0
dle.
2
Release the safety button 3.
1
I
Stopping:
Release the switch lever 2.
English - 3
pull the height of rake
move up or down to the de-
height Moss Leaves
(cm) Thatch Twigs
- 3
2
7
12
17
22
27