Fcc Statement - TCL Sweeva 2000 Guia De Inicio Rapido

• Please close the door of the room if you do not want the robot to enter. During cleaning, the robot
may enter other rooms and continue cleaning.
• In most cases, the anti-fall sensor will prevent the robot from roller down the stairs. If the sensor
is dirty or used on a carpet or on a reflective / very dark floor, the effect of the sensor will be
compromised it is recommended to set up physical barriers where the robot may fall.
• Please do not use the robot on the tassels of a carpet in the folding area, so at to prevent the robot
from being entangled. Avoid cleaning dark and high pile carpets or carpets thicker than 1.02/26mm,
as they may cause robot failure.
NOTICE
This symbol on the device or its packaging indicates: Do not dispose of electrical
appliances as unsorted municipal waste; use separate collection facilities. Contact your
local authority for information regarding the collection systems available. If electrical
appliances are disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally obliged to take back
your old appliance for disposal at least free of charge.

FCC STATEMENT

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
RF EXPOSURE WARNING STATEMENTS:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment shall be installed and operated with minimum distance 20cm between the radiator
& body. This device complies with Part 15 of the FCC Rules. operation is subject to the follow two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.