Sony SU-W110 Manual De Instrucciones página 10

Insert two M4 × 20 mm (
3
inch) screws (or equivalent)
that are adequate for the wall
in the screw holes, and tighten
them securely in the order 1
then 2 as shown below. Never
use any supplied screws to fix
the bracket to the wall.
1
Screws (not
supplied)
10
(GB)
13 /
16
Before attaching bracket B, remove the
rear cover and disconnect the AC power
adapter and all the cables from the TV.
For how to remove the rear cover of the
TV, refer to the Operating Instructions
supplied with the TV.
Bracket A
2
Step 4: Attach
bracket B to the TV
1 Remove the four screws as
illustrated below, and detach
the TV stand from the TV.
To prevent damaging the surface
of the LCD display, place the TV
on a soft mat.
Rear of the TV
Soft mat
Table
Notes
• Lay the display face down on a
stable and level surface, with the
base of the stand facing out. Putting
the display face and the base of the
stand on the same level surface will
cause the TV to incline and
therefore be unstable.
• When removing the TV stand, hold
it firmly.
Remove these screws.
TV stand