Assembly - Shop-Vac 3HM Serie Manual Del Usuario

WALL BRACKET INSTALLATION:
1. Select mounting location at a wall stud and/or provide a minimum 8" wide x 12" high x ¾" thick surface,
which is strong enough to hold the weight of the vacuum unit with a full tank of debris.
WARNING –
CAUSING INJURY AND/OR DAMAGE TO THE UNIT.
2. Secure wall bracket to mounting surface with 3 screws provided or other suitable
fastener. (NOTE: The screws provided are adequate ONLY for mounting into wood.
be sure to use the proper, suitable fasteners for mounting vacuum to a surface
other than wood.) Make sure bracket is level.
3. The tool bag hook can be mounted on the wall in close proximity to the vacuum.
Secure with screws provided. Hang tool bag onto hook using loop in back of tool
bag.
ATTACH VAC:
1. Grasp top handle with one hand and place other hand under front of tank.
2. Align tab on back of vacuum (located near top of tank) to engage with slot in
center of wall bracket as vacuum is lowered into bracket.
3. Push downward making sure slots on vacuum (located near the bottom of the
tank) attach to the tabs located at bottom of bracket.
4. Lower top handle on vacuum to lay flat on top of housing. This will secure unit in
bracket.
DETACH VAC:
1. Push release lever on bracket with thumb, while moving top handle on vacuum to
the up position.
2. Grasp top handle with one hand and place other hand under front of tank.
3. Pull upward until vacuum detaches from bracket.
All manuals and user guides at all-guides.com

ASSEMBLY

INADEqUATE MOUNTING COULD ALLOW THE UNIT TO FALL,
PAGE 5