Bimar S246.EU Folleto De Instrucciones página 9

All manuals and user guides at all-guides.com
Fax +32 030 9904733
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger; but dispose of them in accordance with current law.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity, and that the electric plug is grounded. In the event of incompatibility between the
electric outlet and the plug of the appliance, have the outlet replaced with another more suitable
type by professionally qualified personnel, who will make sure that the section of the wires of the
outlet is appropriate for the absorbed power of the appliance. In general, the use of adapters or
extension cords is not recommended; if their use is indispensable, they must conform to existing
safety standards and their current capacity (amperes) must not be less that the maximum of the
appliance.
• Position the appliance far from other sources of heat, inflammable materials (curtains, carpets,
etc.), inflammable gases or explosive materials (spray cans) and from materials that can deform on
exposure to heat. Make sure that there is 100 cm of free space in front of the appliance and 50 cm
on the sides. Do not use the heater in places where it could be subject to shocks in the immediate
vicinity of a bathtub, shower or swimming pool to avoid drops of water falling on the heater or the
heater falling in the water: If the appliance should accidentally get wet or be submerged in water,
remove the plug from the supply socket immediately and dry the unit carefully. Check that no
liquid has gone inside and if in doubt, contact professionally qualified personnel.
• The support surface must be stable (exclude shelf) and not sloping (since the heater could tip over).
• Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges,
is not wound around the utensil, is not twisted up on itself or in the way to prevent the utensil from
being pulled over. Check that you cannot trip over to prevent accidental falls or harm to persons.
• The appliance must not be positioned immediately under a socket.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Do not use the heater in front of or close to an open window.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• All repairs should be made by a competent qualified electrician. In any case you should return the
appliance to this service.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
Attention: The heater must not be used if the heatings are damaged.
OPERATION
The appliance can be regulated by means of the following elements:
Switch: On ( ) and off (0) the heater, and to activate oscillation (right-left) turn the knob
clockwise ( ).
Pilot light: indicate that the heater is on.
Tilt The joit of the base allows you to adjust the stove top or bottom, and direct the heat in
the most comfortable.
and the tip-over safety switch to prevent accidental falls or harm to persons.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9 24
/
Assembly page 9/24