Installing The Adapter Onto The Upper Vacuum Tube (Model 310Bvr Only) - Ryobi 280r Manual Del Operador

INSTALLING THE ADAPTER ONTO THE
UPPER VACUUM TUBE (MODEL 310BVr ONLY)
WARNING: To prevent serious personal
injury, do not install the adapter while the
unit is running.
WARNING: To avoid serious personal injury,
allow the blower to cool before you install the
adapter.
1. Turn the blower upside down (Fig. 4). Hold the blower
between your knees to install the adapter and
vacuum tubes.
2. Locate the hole in the door. The door lock tab is
recessed in the hole (Fig. 5). Press the door lock tab
toward the front of the unit (away from the handle) to
release the lock and open the door (Fig. 6).
3. Align the adapter's three (3) slots with the unit's three
(3) hooks (Fig. 6). Push firmly so all three (3) hooks
snap through (Fig. 7).
ASSEMBLY INSTRUCTIONS
Fig. 4
Hole with
Door Lock
Tab
Recessed
Inside
Tab
Fig. 5
4. Align the arrow on the upper vacuum tube with the
arrow on the adapter. Slide the upper vacuum tube
onto the adapter (Fig. 8).
NOTE: The arrows must align properly to install the
vacuum tubes correctly.
Hooks (3)
Fig. 6
Fig. 7
Fig. 8
9