Publicidad
Idiomas disponibles
Idiomas disponibles
METHODS OF MEASUREMENT
With double-mass flywheels that come with an even number
of bolts at the clutch pressure plate, apply the lever at the
center and measure the clearance by using the torque
setting angular gauge.
This method works with most double-mass flywheels and
should be preferred.
With double-mass flywheels that come with an odd number
of bolts at the clutch pressure plate, don't apply the lever at
the center and measure the clearance by counting the teeth
on the cranking ring.
Measuring the clearance angle with a timing wheel
1.
Screw two appropriately sized mounting bolts (6) into the
threads of the clutch pressure plate, facing each other.
2.
Apply the lever (7) so that the square adaptor is located
over the center of the flywheel.
3.
Block the flywheel by using the locking tools (1).
4.
Install the angular dial indicator, using the locking tool for
angular dial indicator (3) and holder (4)
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Publicidad
