Televes QPSK-PAL CI Manual De Instrucciones página 46

User manual
- Full Screen: The picture adapts to the
whole screen but its contents are
deformed.
To carry out a modification the
be pressed until the desired parameter flas-
hes. Then the parameter can be modified
just pressing the and keys.
e.- Configuration menu
Through this menu the address of the unit
can be selected (so that it can be controlled
by the Headend Controller CDC). To be able
to control a headend remotely each device
should have a different address (1 to 254).
From this menu you can switch between fre-
quency and channel table mode.
CONFIG
CDCAddr: 001
Mode:
Frecuency
All manuals and user guides at all-guides.com
CONFIG
CDCAddr: 001
Chan. table:
CCIR N.Z.Ind
key must
The following channel tables are available:
Table 1: CCIR
Table 2: CCIR, New Zealand and Indonesia.
Italian channels.
Table 3: China, Taiwan and CCIR hyper-
band.
Table 4: M/N, Chile.
Table 5: France.
Table 6: Australia.
Table 7: Southafrica, K1 (8 MHz), I (Ireland,
8MHz).
Table 8: Former URSS and OIRT.
To carry out a modification the
be pressed until the desired parameter flas-
hes. Then the correspondent parameter can
be modified by pressing
f.- Scan transponder menu
This menu allows the user to repeat the
exploration of the input signal, for example,
if the names of the services haven't been
found. To force a new exploration just press
This menu only appears when the unit is
hooked.
key must
and
.
46
STEREO QPSK-PAL CI
or
.
SCAN TRANSP
Press or
To scan
again